Scissor lift 5,0 T with lifting runways and auxiliary wheel-free lift and play detectors
This scissor lift GALAXIE551ECT, is especially designed to meet vehicle inspection requirement, meets all expectations of ourcustomers.
Thanks to a lifting capacity of 5T and extra long runways 5,10 m, the GALAXIE551ECT can accomodate to almost all, including commercial vans and motorhome.
A super fast raising time is provided thanks to the use of two hydraulic groups working simultaneously.
Options / Accessories
2x hydraulic axle play detectors units, each with 4 combined and opposed movements
LED Torch lamp, wireless, used as command unit for play detector, with charging station on the power unit cabinet
Removable link bar between the 2 runways, for play detectors
Rear side slip plates, with large length 2000 mm, remotely locked/unlocked from the lift command unit
Set of 4 LED ligthing units, with magnets, freely adjustables, with switches
This scissor lift GALAXIE551ECT, is especially designed to meet vehicle inspection requirement, meets all expectations of ourcustomers.
Thanks to a lifting capacity of 5T and extra long runways 5,10 m, the GALAXIE551ECT can accomodate to almost all, including commercial vans and motorhome.
A super fast raising time is provided thanks to the use of two hydraulic groups working simultaneously.
Size (in mm) :
Parcel Nr.1 : 5420 x 700 x 830 mm
Parcel Nr : 1300 x 700 x 560 mm
Weight (en kg):
Parcel Nr.1 : 2800 kg
Parcel Nr.2 : 170 kg
Similar equipment
2,0 T jacking beams without running wheels
Universal and indispensable solution for jacking under axle.
This jacking beams 2,0 T is designated to run between the two platforms of the lift, or in a pit, to be positioned exactly under the vehicle’s axle to be raised.
The lifting movement is done by an hydraulic lifting cylinder, with oil pressure created by an air-hydraulic motor integrated in the jacking beam. The jacking beam is only air supplied (no power), and features safety latching and savety overloading devices. The lowering movement requires two hands for safety reason, with a “hold to run” command.
2,6 T jacking beam without running wheels
Universal and indispensable solution for jacking under axle.
This jacking beams 2,6 T is designated to run between the two platforms of the lift, or in a pit, to be positioned exactly under the vehicle’s axle to be raised.
The lifting movement is done by an hydraulic lifting cylinder, with oil pressure created by an air-hydraulic motor integrated in the jacking beam. The jacking beam is only air supplied (no power), and features safety latching and savety overloading devices. The lowering movement requires two hands for safety reason, with a “hold to run” command.
Double scissor low profile lift 3,0 T
This electro-hydraulic wheel free lift, features a lifting height of 1900 mm, providing optimal access to the vehicle underbody for repair or service works.
Set 8 universal adaptators
Compatible with vehicle lifting 4619316
Set, 8 universal adaptors, with oblong fixing hole for continuous and accurate position adjustment. The adaptor gets quickly and safely clamped onto the lifting platform, thanks to its thumb screw, to be hand tightened thumb screw.
Lifting table – 1200 kg
This lifting table has been especially designed to easily and safely remove and install heavy batteries from electric vehicles, in conjunction with the use of a 2-post lift such as the Azur42AH.
Photocell for installation under low ceiling
Compatible with 2-post lifts AZUR35CH, AZUR42CH, AZUR50CH and AZUR50WH